Everything must go!
Everything (except shipping) half price
with coupon code FINAL at checkout.
This is the full height Pibow case for the Raspberry Pi model B+ and Raspberry Pi2 or Pi3 model B/B+, custom tailored by those crafty pirates at Pimoroni to wrap around and protect your E-paper Hat. It comes with two versions of the clear acrylic top layer, one with button holes and one without, to suit your preferred configuration.
Assembling the case from layer 0 upwards, the Pi fits on top of layer 2, the E-paper HAT attaches after layer 7, then layer 8 and either the plain clear lid or the one with the holes for the buttons, if you are using them. To assist, if you need to remove the E-paper HAT at some point, there are two notches at the rear of layer 7 where you can insert a small electrical screwdriver to gently lever the GPIO connector away from the Pi.